RGB Spectrum Quadra Guida Utente Pagina 38
- Pagina / 132
- Indice
- RISOLUZIONE PROBLEMI
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
OPERATIONS
Setting Output Format
350-7951 Quadra User’s Guide 30
. . . . .
2. To enable automatic detection and loading of a display timing set type
the following command (using upper or lower case characters).
H OPREF EDID Enter
• This will cause Quadra to read the preferred timing parameters from
your display device, and then search for a match in the Factory
Timing List. If it finds a match (for example, one that you have
previously stored), it selects and loads those parameters.
• If Quadra does not find a match in the “user entry” section, it searches
through all factory defined entries and loads the closest match.
These steps should be repeated for each of the Quadra output channels (1 - 4).
this command enables you to set the output display parameters, using values
that are stored in the system’s “Factory Timing List
.”
MANUALLY
LOADING OUTPUT
. . . . . . . . .
PARAMETERS
Use the following steps if you want to manually enter your own output
parameters:
1. Ensure that the display(s) that you want to set up are connected to
selected Quadra outputs.
2. Obtain a copy of the display device’s operations manual or technical
guide, and make a note of the following parameters: monitor type,
format (analog or digital), resolution, refresh rate, sync, sync polarity
and interlace.
3. To enable manual loading of a display timing set type the following
command (using upper or lower case characters).
H OPREF INT Enter
4. Using the command line interface, request help text for the command.
Using upper or lowercase characters, type:
H OPTMLOAD Enter
This action displays the command’s parameters and arguments in the
command window.
Figure 3-3.
Help Text — Output Timing Load Command
5. Show the timing list. Type:
TMLIST Enter
- User’s Guide 1
- TABLE OF CONTENTS 5
- INTRODUCTION 9
- . . . . 10
- INSTALLATION AND SETUP 16
- REAR PANEL 19
- OPERATIONS 35
- CREATING A BACKGROUND 57
- COMMAND LINE INTERFACE 60
- Factory Timing List 88
- “OutPutTiMing” 88
- “OutPutTiMingSAVE” function 88
- OutPutTiMingNAME” 88
- IMAGE CONCEPTS 90
- COMMUNICATIONS SETUP 98
- IP Address Setup 101
- IPADDR 192.168.100.15 101
- . . . . . . . . 102
- CONNECTOR TYPES 105
- COMPOSITE VIDEO CONNECTOR 106
- S-VIDEO CONNECTOR 107
- AND PINOUTS 108
- CONNECTOR TYPE 108
- DVI-I CONNECTOR 110
- ETHERNET CONNECTOR 112
- RS-232 CONNECTOR 113
- FIRMWARE UPGRADES AND 114
- TROUBLESHOOTING 114
- TECHNICAL SPECIFICATIONS 123
- • 3 wire (Sync On Green) 125
- Parameter Storage 129
- RestoreFactoryDefaults 129
Faure FRA289W manuales
Manuales del propietario y guías del usuario para No Faure FRA289W.
Ofrecemos 1 manuales en pdf Faure FRA289W para descargar gratis por tipos de documentos: Manual de usuario
Commenti su questo manuale